Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 247)

Brocade Mobility RFS Controller System Reference Guide 235
53-1003099-01
5
Enable Balance Band Loads by Radio (within the Band Load Balancing field) to distribute an Access
Points client traffic load across both the 2.4 and 5 GHz radio bands.
Set the following Channel Load Balancing settings:
Enable Balance AP Loads (within the AP Load Balancing field) to distribute client traffic evenly
amongst neighbor Access Points.
Set the following Advanced client load balance values:
Define the following AP Load Balancing settings:
Balance 2.4 GHz Channel
Loads Select this option to balance an Access Point’s 2.4 GHz client load across all channels. This setting
is enabled by default.
Balance 5 GHz Channel
Loads Select this option to balance an Access Point’s 5 GHz client load across all channels. This setting is
enabled by default.
Max. 2.4 GHz Difference
Considered Equal Set the maximum load difference (from 1 - 100%) considered equal when comparing 2.4 GHz client
loads. The default setting is 1%.
Min. Value to Trigger 2.4
Ghz Channel Balancing Set the threshold (from 1 - 100%) beyond which channel load balancing is triggered in the 2.4 GHz
radio band. The default setting is 5%.
Weightage given to Client
Count Set the weightage (from 1- 100%) applied to client count calculations in the 2.4 GHz radio band. The
default setting is 90%.
Weightage given to
Throughput Set the weightage (from 1- 100%) applied to client throughput calculations in the 2.4 GHz radio
band. The default setting is 10%.
Max. 5 GHz Difference
Considered Equal Set the maximum load difference (from 1 - 100%) considered equal when comparing 5 GHz client
loads. The default setting is 1%.
Min. Value to Trigger 5 Ghz
Channel Balancing Set the threshold (from 1 - 100%) beyond which channel load balancing is triggered in the 5 GHz
radio band. The default setting is 5%.
Weightage given to Client
Count Set the weightage (from 1- 100%) applied to client count calculations in the 5 GHz radio band. The
default setting is 90%.
Weightage given to
Throughput Set the weightage (from 1- 100%) applied to client throughput calculations in the 5 GHz radio band.
The default setting is 10%.
Min. Value to Trigger
Balancing Set a value (from 1 - 100%) used to trigger client load balancing when exceeded. The default setting
is 5%.
Max. AP Load Difference
Considered Equal Set the maximum load balance differential (from 1 - 100%) considered equal when comparing
neighbor Access Point client loads. The default setting is 1%.
Weightage given to Client
Count Set the weightage (from 1- 100%) applied to client count in an Access Point’s overall load
calculation. The default setting is 90%.
Weightage given to
Throughout Set the weightage (from 1- 100%) applied to client throughput in an Access Point’s overall load
calculation. The default setting is 10%.