Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 784)

772 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
The Proxy tab displays the following:
10. Select the Device Brief Info tab from the top of the screen.
The Device Brief Info screen is divided into 2 fields, All Roots and Mesh Points and
MeshPoint Details.
Interface ID The IFID uniquely identifies an interface associated with the MPID. Each mesh point on a device
can be associated with one or more interfaces.
State Displays the Link State for each mesh point:
•
Init - indicates the link has not been established or has expired.
•
Enabled - indicates the link is available for communication.
•
Failed - indicates the attempt to establish the link failed and cannot be retried yet.
•
In Progress - indicates the link is being established but is not yet available.
Timeout Displays the maximum value in seconds that the link is allowed to stay in the In Progress state
before timing out.
Keep Alive Yes indicates that the local MP will act as a supplicant to authenticate the link and not let it expire
(if possible). No indicates that the local MP does not need the link and will let it expire if not
maintained by the remote MP.
Mesh Point Name Displays the name of each configured mesh point in the RF Domain.
Destination Addr The destination is the endpoint of mesh path. It may be a MAC address or a mesh point ID.
Proxy Address Displays the MAC Address of the proxy used in the mesh point.
Age Displays the age of the proxy connection for each of the mesh points in the RF Domain.
Proxy Owner The owner’s (MPID) is used to distinguish the neighbor device.
Persistence Displays the persistence (duration) of the proxy connection for each of the mesh points in the RF
Domain.
VLAN The VLAN ID used as a virtual interface with this proxy. A value of 4095 indicates that there is no
VLAN ID.