Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 128)

116 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
15. Select OK to save the changes and overrides to the security configuration. Select Reset to
revert to the last saved configuration.
Radio Override Configuration
Profile Interface Override Configuration
Access Points can have their radio profile configurations overridden once their radios have
successfully associated to the network.
To define a radio configuration override from the Access Point’s associated controller or service
platform:
1. Select Devices from the Configuration tab.
The Device Configuration screen displays a list of managed devices or peer controllers, service
platforms or Access Points.
2. Select an Access Point (by double-clicking it) from amongst those displayed within the Device
Configuration screen.
Devices can also be selected directly from the Device Browser in the lower, left-hand, side of
the UI.
3. Select Profile Overrides from the Device menu to expand it into sub menu options.
4. Select Interface to expand its sub menu options.
5. Select Radios.
FIGURE 43 Profile Overrides - Radios screen
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.