Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 221)

Brocade Mobility RFS Controller System Reference Guide 209
53-1003099-01
5
To define the configuration of a VVRP group:
1. Select Devices from the Configuration tab.
The Device Configuration screen displays a list of managed devices or peer controllers, service
platforms or Access Points.
2. Select a target device (by double-clicking it) from amongst those displayed within the Device
Configuration screen.
Devices can also be selected directly from the Device Browser in the lower, left-hand, side of
the UI.
3. Select Profile Overrides from the Device menu to expand it into sub menu options.
4. Select VRRP.
NOTE
VRRP support is only available on BR7131 model access points, and not on other Access Point
models.
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
FIGURE 102 Profile Overrides - VRRP screen
5. Review the following VRRP configuration data to assess if a new VRRP configuration is required
of is an existing VRRP configuration requires modification or removal:
Virtual Router ID Lists a numerical index (1 - 254) used to differentiate VRRP configurations. The index is
assigned when a VRRP configuration is initially defined. This ID identifies the virtual router a
packet is reporting status for.