Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 550)

538 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
FIGURE 102 Advanced Profile MINT screen - IP Add tab
11. Set the following Link IP parameters to complete the MINT network address configuration:
12. Select the VLAN tab to display the link IP VLAN information shared by the devices managed by
the MINT configuration.
IP Define the IP address used by peers for interoperation when supporting the MINT protocol.
Port To specify a custom port for MiNT links, select this option and use the spinner control to define the
port number between 1 and 65,535.
Routing Level Use the spinner control to define a routing level of either 1 or 2.
Listening Link Specify a listening link of either 0 or 1. UDP/IP links can be created by configuring a matching pair of
links, one on each end point. However, that is error prone and doesn’t scale. So UDP/IP links can
also listen (in the TCP sense), and dynamically create connected UDP/IP links when contacted.
Forced Link Check this box to specify the MiNT link as a forced link.
Link Cost Use the spinner control to define a link cost between 1 - 10,000. The default value is 100.
Hello Packet Interval Set an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the transmission of hello packets.
The default interval is 15 seconds.
Adjacency Hold Time Set a hold time interval in either Seconds (2 - 600) or Minutes (1 - 10) for the transmission of hello
packets. The default interval is 46 seconds.
IPSec Secure Enable this option to provide IPSec secure peer authentication on the MiNT connection (link). This
option is disabled by default.
IPSec GW Select the numerical IP address or administrator defined hostname of the IPSec gateway.