Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 617)

Brocade Mobility RFS Controller System Reference Guide 605
53-1003099-01
10
FIGURE 26 WIPS Signatures Configuration screen
23. If adding anew WIPS signature, define a Name to distinguish it from others with similar
configurations. The name cannot exceed 64 characters.
24. Set the following network address information for a new or modified WIPS Signature:
Enable Signature Select the check box to enable the WIPS signature for use with the profile. The default signature is
enabled.
BSSID MAC Define a BSS ID MAC address used for matching and filtering with the signature.
Source MAC Define a source MAC address for packets examined for matching, filtering and potential device exclusion
using the signature.
Destination MAC Set a destination MAC address for the packet examined for matching, filtering and potential device
exclusion with the signature.
Frame Type to Match Use the drop-down menu to select a frame type for matching and filtering with the WIPS signature.
Match on SSID Set the SSID used for matching and filtering with the signature. Ensure it’s specified properly or the SSID
won’t be properly filtered.
SSID Length Set the character length of the SSID used for matching and filtering with this signature. The maximum
length is 32 characters.