Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 202)

190 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 86 VPN Step-By-Step Wizard - Step 1
Set the following VPN values for step 1:
Select the Next button to proceed to step 2.
If any of the required values within the step 1 screen are not set properly, the second
wizard screen will not display until they are properly set.
Tunnel Name Provide a name for the tunnel in the Tunnel Name field.
Tunnel Type Select the tunnel type being created. Two types of tunnels can be created. Site to Site (the default
setting) is used to create a tunnel between two remote sites. Remote Access is used to create a tunnel
between an user device and a network.
Interface Select the interface to use. Interface can be a Virtual LAN (VLAN) or WWAN or PPPoE depending on the
interfaces available on the device.
Traffic Selector This field creates the Access Control List (ACL) that is used to control who uses the network. Provide the
Source and Destination IP address ranges with their net mask. Click the Add Rule button to add the rule
into the ACL.