Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 219)

Brocade Mobility RFS Controller System Reference Guide 207
53-1003099-01
5
FIGURE 100 Security Source Dynamic NAT screen
8. Select the ACL whose IP rules are applied to the policy based forwarding rule. A new ACL can
be defined by selecting the Create icon, or an existing set of IP ACL rules can be modified by
selecting the Edit icon.
9. Use the IP Address Range table to configure IP addresses and address ranges that can used
to access the Internet.
10. Select + Add Row to set the interface, overload and NAT pool settings for the Bridge NAT
configuration.
ACL Precedence Set the priority (from 1 - 5000) for the ACL. The lower the value, the higher the priority
assigned to these ACL rules.
Interface Lists the outgoing layer 3 interface on which traffic is re-directed. The interface can be an
Access Point wwan or pppoe interface. Traffic can also be redirected to a designated
VLAN.
NAT Pool Displays the NAT pool used by this Bridge NAT entry. A value is only displayed only when
Overload Type has been set to NAT Pool.
Overload IP Lists whether the single global address supporting numerous local addresses.
Overload Type Lists the overload type utilized when several internal addresses are NATed to only one or
a few external addresses. Options include NAT Pool, One Global Address and Interface IP
Address. Interface IP Address is the default setting.