Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 778)

766 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
2. Select a RF Domain from under the System node on the top, left-hand side, of the screen.
3. Select Mesh Point.
The MCX Geographical View displays by default.
FIGURE 19 RF Domain - Mesh Point MCX Geographical View screen
The MCX Geographical View screen displays a map where icons of each device in the RF Domain is
overlaid. This provides a geographical overview of the location of each RF Domain member device.
4. Use the N, W, S and E buttons to move the map in the North, East, West and South directions
respectively. The slider next to these buttons enables zooming in and out of the view. The
available fixed zoom levels are World, Country, State, Town, Street and House.
5. Use the Maximize button to maximize this view to occupy the complete screen. Use the Refresh
button to update the status of the screen.
6. Select the MCX Logical View tab to view a logical representation of the Meshpoint.