Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 203)

Brocade Mobility RFS Controller System Reference Guide 191
53-1003099-01
5
FIGURE 87 VPN Step-By-Step Wizard - Step 2
Set the following VPN quick setup values for step 2:
Click the Add Peer button to add the tunnel peer information into the Peer(s) table. This table lists
all the peers set for the VPN Tunnel.
Select Next to proceed to the step 3 screen. Use the Back button to go to the previous step.
Peer Select the type of peer for this device when forming a tunnel. Peer information can be either an IP
Address (default value) or hostname. Provide the IP address or the host name of the peer device.
Authentication Configure how devices authenticate on opposite ends of the tunnel connection.
•
Certificate – The devices use certificates to authenticate with each other (default value)
•
Pre-Shared Key – The devices use pre-shared key to authenticate.
Local Identity Configure the local identity for the VPN tunnel.
•
IP Address – The local identity is an IP address (default value).
•
FQDN – The local identity is a Fully Qualified Domain Name (FQDN).
•
Email – The local identity is an E-mail address.
Remote Identity Configure the remote identity for the VPN tunnel.
•
IP Address – The remote identity is an IP address (default value).
•
FQDN – The remote identity is a FQDN.
•
Email – The remote identity is an E-mail address.
IKE Policy Configure an IKE policy to use when creating this VPN Tunnel. The following options are available:
•
Use Default – Select this option to use the default IKE profiles.
•
Create new Policy – Select this option to create a new IKE policy.