Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 261)

Brocade Mobility RFS Controller System Reference Guide 249
53-1003099-01
5
1. Select Configuration > Devices > MINT Policy to display the MINT Policy screen.
FIGURE 129 MINT Policy Configuration screen
2. Configure the following parameters to configure the MINT policy:
3. Select OK to save the changes. Select Reset to revert to the last saved configuration.
Level 2 Area ID Define a Level 2 Area ID for the Mint Policy. The Level 2 Area ID is the global mint
area identifier. This area identifier separates two overlapping mint networks and
need only be configured if the administrator has two mint networks that share the
same packet broadcast domain.
MTU Specify a MTU value for the mint policy between 900 and 1,500. The MTU setting
specifies the maximum packet size that will be used for mint packets. Larger
packets will be fragmented so they fit within this packet size limit. The administrator
may want to configure this parameter if the mint backhaul network requires or
recommends smaller packet sizes. The default value is 1500.
UDP/IP Encapsulation
Port Specify the port to use for UDP/IP encapsulation between 2 and 65,534. This value
specifies an alternate UDP port to be used by mint packets and must be an even
number. This port number will be used by mint control packets, and this port value
plus 1 will be used to carry mint data packets. The default value is 24576.