Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 540)

528 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
FIGURE 97 Mesh Point Auto Channel Selection - Root Path Metric screen
14. Set the following Path Method Root Path Metrics (applying to both the 2.4 GHz and 5.0/4.9
GHz frequencies):
Channel Width Set the channel width meshpoint automatic channel scan should assign to the selected radio. The
available options are:
•
Automatic – Defines the channel width as calculated automatically. This is the default value.
•
20 MHz – Set the width between two adjacent channels as 20 MHz.
•
40 MHz – Set the width between two adjacent channels as 40 MHz.
Priority Meshpoint Define the meshpoint assigned priority over other available mesh points. When configured, a mesh
connection is established with this mesh point. If not configured, a meshpoint is automatically
selected.
Meshpoint: Path Minimum Set the minimum path metric (from 100 - 20,000) for mesh connection establishment. The default
setting is 1000.
Meshpoint: Path Metric
Threshold Configure a minimum threshold (from 800 - 65535) for triggering an automatic channel selection
for meshpoint selection. The default is 1500.
Meshpoint: Tolerance
Period Configure a duration to wait before triggering an automatic channel selection for the next mesh
hop. The default is one minute.