Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 789)

Brocade Mobility RFS Controller System Reference Guide 777
53-1003099-01
15
The Security tab displays the following:
The Proxy tab displays the following:
12. Select Device Data Transmit.
Mesh Point Name Displays the name of each configured mesh point in the RF Domain.
Destination Addr The destination is the endpoint of mesh path. It may be a MAC address or a mesh point ID.
Radio Interface This indicates the interface that is used by the device to communicate with this neighbor. The
values are 2.4 and 5.8, indicating the frequency of the radio that is used to communicate with the
neighbor.
Interface ID The IFID uniquely identifies an interface associated with the MPID. Each mesh point on a device
can be associated with one or more interfaces.
State Displays the Link State for each mesh point:
•
Init - indicates the link has not been established or has expired.
•
Enabled - indicates the link is available for communication.
•
Failed - indicates the attempt to establish the link failed and cannot be retried yet.
•
In Progress - indicates the link is being established but is not yet available.
Timeout Displays the maximum value in seconds that the link is allowed to stay in the In Progress state
before timing out.
Keep Alive Yes indicates the local MP acts as a supplicant to authenticate the link and not let it expire (if
possible). No indicates that the local MP does not need the link and will let it expire if not
maintained by the remote MP.
Mesh Point Name Displays the name of each configured mesh point in the RF Domain.
Destination Addr The destination is the endpoint of mesh path. It may be a MAC address or a mesh point ID.
Proxy Address Displays the MAC Address of the proxy used in the mesh point.
Age Displays the age of the proxy connection for each of the mesh points in the RF Domain.
Proxy Owner The owner (MPID) is used to distinguish the device that is the neighbor.
VLAN The VLAN ID used as a virtual interface with this proxy. A value of 4095 indicates that there is no
VLAN ID.