Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 194)

182 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 81 Network Service Alias Add screen
9. If adding a new Network Service Alias Rule, provide it a name up to 32 characters. Ensure a $
precedes the name.
10. Select + Add Row and provide the following configuration parameters:
11. Within the Range field, use the + Add Row button to specify the Start IP address and End IP
address for the service alias range or double-click on an existing service alias range entry to
edit it.
12. Select OK when completed to update the service alias rules. Select Reset to revert the screen
back to its last saved configuration.
Protocol Specify the protocol for which the alias has to be created. Use the drop down to select the protocol from
eigrp, gre, icmp, igmp, ip, vrrp, igp, ospf, tcp and udp. Select other if the protocol is not listed. When a
protocol is selected, its protocol number is automatically selected.
Source Port
(Low and High) This field is only relevant if the protocol is either tcp or udp.
Specify the source ports for this protocol entry. A range of ports can be specified. Select the Enter Ranges
button next to the field to enter a lower and higher port range value. Up to eight (8) such ranges can be
specified.
Destination Port (Low
and High) This field is only relevant if the protocol is either tcp or udp.
Specify the destination ports for this protocol entry. A range of ports can be specified. Select the Enter
Ranges button next to the field to enter a lower and higher port range value. Up to eight (8) such ranges
can be specified.