Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 225)

Brocade Mobility RFS Controller System Reference Guide 213
53-1003099-01
5
The Device Configuration screen displays a list of devices or peer controllers, service platforms
or Access Points.
2. Select a target device (by double-clicking it) from amongst those displayed within the Device
Configuration screen.
Devices can also be selected directly from the Device Browser in the lower, left-hand, side of
the UI.
3. Select Profile Overrides from the Device menu to expand it into sub menu options.
4. Select Critical Resources.
FIGURE 105 Critical Resources screen - List of Critical Resources tab
The screen lists the destination IP addresses or interfaces (VLAN, WWAN, or PPPoE) used for
critical resource connection. IP addresses can be monitored directly by the controller, service
platform or Access Point whereas a VLAN, WWAN or PPPoE must be monitored behind an
interface.
5. The Critical Resource Name table displays the name of the resource(s) configured on this
device.
6. Click the Add button at the bottom of the screen to add a new critical resource and connection
method, or select an existing resource and select Edit to update the resource’s configuration. If
adding a new critical resource, assign it a name up to 32 characters.