Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 535
Brocade Mobility RFS Controller System Reference Guide
523
53-1003099-01
8
FIGURE 94
Mesh Point - Settings Screen
6. Define the following Settings:
MeshConnex Policy
If adding a new policy, specify a name for the MeshConnex Policy. The name cannot be edited later
with other configuration parameters. Until a viable name is provided, the Settings tab cannot be
enabled for configuration.
Is Root
Select the root behavior of this mesh point. Select True to indicate this mesh point is a root node for
this mesh network. Select False to indicate this mesh point is not a root node for this mesh network.
Root Selection Method
Use the drop-down menu to determine whether this meshpoint is the root or non-root meshpoint.
Select either None (the default setting) or auto-
Set as Cost Root
Select this option to set the mesh point as the cost root for meshpoint root selection. This setting is
disabled by default.