Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 294)

282 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
6
FIGURE 22 WLAN Policy Client Settings screen
4. Define the following Client Settings for the WLAN:
Enable Client-to-Client
Communication Select this option to enable client to client communication within this WLAN. The default is
enabled, meaning clients are allowed to exchange packets with other clients. It does not
necessarily prevent clients on other WLANs from sending packets to this WLAN, but as long as this
setting also disabled on that WLAN, clients are not permitted to interoperate.
Wireless Client Power Use this parameter to set the maximum transmit power (between 0 - 20 dBm) communicated to
wireless clients for transmission within the network. The default value is 20 dBm.
Wireless Client Idle Time Set the maximum amount of time wireless clients are allowed to be idle within this WLAN. Set the
idle time in either Seconds (60 - 86,400), Minutes (1 - 1,440), Hours (0 - 24) or Days (0 - 1). When
this setting is exceeded, the client is no longer able to access resources and must re-authenticate.
The default value is 1,800 seconds.
Max Firewall Sessions per
Client Select this option to set the maximum amount of sessions (between 10 - 10,000) clients within the
network over the Firewall. When enabled, this parameter limits the number of simultaneous
sessions allowed by the Firewall per wireless client. This feature is disabled by default.
Max Clients Allowed Per
Radio Use the spinner control to set the maximum number of clients (from 0 - 256) allowed to associate
to each radio within this WLAN. The default setting is 256.