Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 251)

Brocade Mobility RFS Controller System Reference Guide 239
53-1003099-01
5
FIGURE 120 Advanced Profile MINT screen - IP tab
14. Set the following Link IP parameters to complete the MINT network address configuration:
15. Select the VLAN tab to display link IP VLAN information shared by the devices managed by the
MINT configuration.
IP Define or override the IP address used by peers for interoperation when supporting the MINT
protocol.
Port To specify a custom port for MiNT links, select this option and use the spinner control to define or
override the port number (1 - 65,535).
Routing Level Use the spinner control to define or override a routing level of either 1 or 2.
Listening Link Specify a listening link of either 0 or 1. UDP/IP links can be created by configuring a matching pair
of links, one on each end point. However, that is error prone and doesn’t scale. So UDP/IP links can
also listen (in the TCP sense), and dynamically create connected UDP/IP links when contacted. The
typical configuration is to have a listening UDP/IP link on the IP address S.S.S.S, and for all the APs
to have a regular UDP/IP link to S.S.S.S.
Forced Link Check this box to specify the MiNT link as a forced link.
Link Cost Use the spinner control to define or override a link cost from 1 - 10,000. The default value is 100.
Hello Packet Interval Set or override an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the transmission of hello
packets. The default interval is 15 seconds.
Adjacency Hold Time Set or override a hold time interval in either Seconds (2 - 600) or Minutes (1 - 10) for the
transmission of hello packets. The default interval is 46 seconds.
IPSec Secure Enable this option to provide IPSec secure peer authentication on the MiNT connection (link). This
option is disabled by default.
IPSec GW Select the numerical IP address or administrator defined hostname of the IPSec gateway.