Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 30
18
Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
3
•
Primary DNS - Enter an IP Address for the main Domain Name Server providing DNS
services for the LAN interface.
•
Secondary DNS - Enter an IP Address for the backup Domain Name Server providing
DNS services for the LAN
interface.
Use the spinner control to select a VLAN ID for the LAN Interface. Optionally select Advanced VLAN
Configuration to populate the screen with additional VLAN parameters for the LAN interface.
Select Next. If Router was selected as the Access Point mode the wizard displays the WAN
Configuration screen. If Bridge was selected, the wizard proceeds to the Wireless LAN Setting
screen.
FIGURE 6
Initial Setup Wizard - WAN Configuration
Set the following DHCP and Static IP Address/Subnet information to define how traffic is routed
between the local network (LAN) and the Internet or external network (WAN).
•
Use DHCP - Select Use DHCP to enable an automatic network address configuration using
local DHCP server resources.
•
Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the WAN interface.
These are required fields
•
Default Gateway -Enter an IP Address for the default gateway on the WAN interface. If
Use DHCP is enabled, this field is not configurable.