Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 250)

238 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
8. Define or override the following MINT Link Settings in respect to devices supported by the
profile:
9. Select Tunnel Controller Load Balancing (Level 1) to enable load balancing through a WLAN
tunnel controller. This setting is disabled by default.
10. Enter a 64 character maximum Preferred Tunnel Controller Name the Access Point utilizes as a
preferred resource to tunnel extended VLAN traffic.
11. Select OK to save the changes and overrides made to the Settings tab. Select Reset to revert to
the last saved configuration.
12. Select the IP tab to display the link IP network address information shared by the devices
managed by the MINT configuration.
FIGURE 119 Advanced Profile MINT screen - IP tab
13. The IP tab displays the IP address, Routing Level, Listening Link, Port, Forced Link, Link Cost,
Hello Packet Interval and Adjacency Hold Time devices use to securely communicate amongst
one another. Select Add to create a new Link IP configuration or Edit to override an existing
MINT configuration.
MLCP IP Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MLCP is used to
create a UDP/IP link from the device to a neighbor. The neighboring device does not need to be a
controller or service platform, it can be another Access Point with a path to the controller or service
platform.
MLCP VLAN Select this option to enable MINT MLCP by VLAN. The neighboring device does not need to be a
controller or service platform, it can be another Access Point with a path to the controller or service
platform.
Tunnel MiNT across
extended VLAN Select this option to tunnel MiNT protocol packets across an extended VLAN. This setting is disabled
by default.