Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 721)

Brocade Mobility RFS Controller System Reference Guide 709
53-1003099-01
14
To restart controller or service platform adopted Access Points:
1. Select the Operations > Devices > Adopted AP Restart
FIGURE 9 Adopted AP Restart screen
2. The Adopted AP Restart table displays the following information for each Adopted AP:
3. To restart an Access Point or Access Points select the checkbox to the left of each AP to restart
and configure the following options:
Hostname Displays the specified Hostname for each known Access Point.
MAC Address Displays the primary Media Access Control (MAC) or hardware address for each known Access
Point.
Type Displays the Access Point model number for each adopted Access Point.
Version Displays the current firmware version for each adopted Access Point.
Reason Lists the administrator defined reason an adopted device has been queued for a restart.
Force Reload To force a reload of an Access Point or Access Points, select the Force Reload checkbox next to
each AP.
Delay (Seconds) Specify the amount of time, in seconds, before the Access Point restart should be executed.
Delaying the restart may allow a selected Access Point to complete its current duty cycle.
Message Displays any messages associated with each adopted Access Point
Reload Status Click the Reload Status button next to each adopted Access Point to display their current status
information.