Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 365)

Brocade Mobility RFS Controller System Reference Guide 353
53-1003099-01
7
9. Select an accounting configuration from the table and select Edit, or select Add to create a new
RADIUS accounting configuration:
10. To edit an existing accounting profile, select the profile then Edit. To add a new policy select
Add.
Server ID Displays the numerical server index (1-6) for the accounting server assigned when added to the
Mobility operating system.
Host Displays the IP address or hostname of the RADIUS authentication server.
Port Displays the port on which the RADIUS server listens to traffic within the network. The port range is
1 to 65,535. The default port is 1813.
Server Type Displays the type of AAA server in use either Host, onboard-self, or onboard-controller.
Request Timeout Displays the time between 1 and 60 seconds for the wireless controller’s re-transmission of
request packets. If this time is exceeded, the authentication session is terminated.
Request Attempts Displays the number of attempts a client can retransmit a missed frame to the RADIUS server
before it times out of the authentication session. The available range is between 1 and 10
attempts. The default is 3 attempts.
DSCP Displays the DSCP value as a 6-bit parameter in the header of every IP packet used for packet
classification. The valid range is between 0 and 63 with a default value of 34.
Request Proxy Mode Displays the method of proxy that browsers communicate with the RADIUS authentication server.
The mode could either be None, Through Wireless Controller, or Through RF Domain Manager.
NAI Routing Enable Displays NAI routing status. AAA servers identify clients using the NAI. The NAI is a character string
in the format of an e-mail address as either user or user@ but it need not be a valid e-mail address
or a fully qualified domain name. The NAI can be used either in a specific or generic form. The
specific form, which must contain the user portion and may contain the @ portion, identifies a
single user. The generic form allows all users in a given or without a to be configured on a single
command line. Each user still needs a unique security association, but these associations can be
stored on a AAA server. The original purpose of the NAI was to support roaming between dialup
ISPs. Using NAI, each ISP need not have all the accounts for all of its roaming partners in a single
RADIUS database. RADIUS servers can proxy requests to remote servers for each.