Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 31)

Brocade Mobility RFS Controller System Reference Guide 19
53-1003099-01
3
• VLAN ID for the WAN Interface - Set the VLAN ID (virtual interface) to associate with
the physical WAN Interface. The default setting is VLAN 2100.
• Port for External Network - Select the physical port connected to the WAN interface.
The list of available ports varies based on the RFS4011 controllers or NX4500 and
NX6500 service platform model.
• Enable NAT on the WAN Interface - Select the option to allow traffic to pass between
WAN and LAN interfaces.
Select Next. The wizard displays the Wireless LAN Setting screen to define up to four WLAN
configurations for the controller or service platform.
FIGURE 7 Initial Setup Wizard - Wireless LAN Settings
Set the following parameters for up to four WLAN configurations:
• SSID - Enter or modify the Services Set Identification (SSID) associated with the WLAN. The
WLAN name is
auto-generated using the SSID until changed by the administrator. The maximum number
of characters is 32. Do not use any of these characters (< > | " & \ ? ,).
• WLAN Type - Select a basic authentication and encryption scheme for the WLAN. Available
options include:
• No Authentication and No Encryption (provides no security at all)
• Captive Portal Authentication and No Encryption
• PSK authentication, WPA2 encryption