Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 158)

146 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
The Device Configuration screen displays a list of managed devices or peer controllers, service
platforms or Access Points.
Select a target device (by double-clicking it) from amongst those displayed within the
Device Configuration screen.
Devices can also be selected directly from the Device Browser in the lower, left-hand, side of
the UI.
2. Select Profile Overrides from the Device menu to expand it into sub menu options.
3. Select Network to expand its sub menu options.
4. Select IGMP Snooping.
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override, go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
FIGURE 59 Profile Overrides - Network IGMP Snooping
5. Define or override the following IGMP Snooping parameters for the Bridge VLAN configuration:
Enable IGMP Snooping Select this option to enable IGMP snooping. If disabled, snooping on a per VLAN
basis is also disabled. This feature is enabled by default. If disabled, the settings
under the bridge configuration are overridden. For example, if IGMP snooping is
disabled, but the bridge VLAN is enabled, the effective setting is disabled.
Forward Unknown
Multicast Packets Select this option to enable the forwarding of multicast packets from unregistered
multicast groups. If disabled (the default setting), the unknown multicast forward
feature is also disabled for individual VLANs.