Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 531)

Brocade Mobility RFS Controller System Reference Guide 519
53-1003099-01
8
FIGURE 92 Profile Management Firmware screen
15. Refer to the Auto Install via DHCP Option section to configure automatic configuration file and
firmware updates.
Enable Configuration
Update Select the Enable Configuration Update radio button (from within the Automatic Configuration
Update field) to enable automatic configuration file updates for the profile from an external location.
If enabled (the setting is disabled by default), provide a complete path to the target configuration file
used in the update.
Enable Firmware Upgrade Select this option to enable automatic firmware upgrades (for this profile) from a user defined
remote location. This value is disabled by default.
Start Time (minutes) Use the spinner control to set the number of minutes to delay the start of an auto upgrade
operation. Stagger the start of an upgrade operation as needed in respect to allowing an Access
Point to complete its current client support activity before being rendered offline during the update
operation. The default setting is 10 minutes.