Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 548)

536 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
FIGURE 100 Advanced Profile MINT screen - Settings tab
The Settings tab displays by default.
2. Refer to the Area Identifier field to define the Level 1 and Level 2 Area IDs used by the profile’s
MINT configuration.
3. Define the following Device Heartbeat Settings in respect to devices supported by the profile:
4. Select the Latency of Routing Recalculation check box (within the Shortest Path First (SPF)
field) to enable the spinner control used for defining a latency period from 0 - 60 seconds. The
default setting has the check box disabled.
5. Define the following MINT Link Settings in respect to devices supported by the profile:
Level 1 Area ID Select the check box to enable a spinner control for setting the Level 1 Area ID between 1 -
4,294,967,295. The default value is disabled.
Designated IS Priority
Adjustment Set a Designated IS Priority Adjustment setting from -255 and 255. This is the value added to
the base level DIS priority to influence the Designated IS (DIS) election. A value of +1 or greater
increases DISiness. The default setting is 0.
MLCP IP Check this box to enable MINT Link Creation Protocol (MLCP) by IP Address. MLCP is used to create
one UDP/IP link from the device to a neighbor. The neighboring device does not need to be a
controller or service platform, it can be another Access Point with a path to the controller or service
platform.
MLCP VLAN Check this box to enable MLCP by VLAN. MLCP is used to create one VLAN link from the device to a
neighbor. That neighboring device does not need to be a controller or service platform, it can be
another Access Point with a path to the controller or service platform.