Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 393)

Brocade Mobility RFS Controller System Reference Guide 381
53-1003099-01
8
FIGURE 2 General Profile - screen
5. If creating a new profile, provide a name (up to 32 characters) within the Profile parameter
field.
6. Use the Type drop-down menu to specify the Brocade device model for which the profile
applies.
Profiles can only be applied to the same device type selected when the profile is initially
created.
7. Refer to the Location field to define the device’s deployment location area.
8. Within the Statistics field, use the NoC Update Interval to set the statistics update interval
(from 0, 5 - 3600 seconds) from the RF Domain manager to its adopting controller.
A value of 0 is allowable for an auto mode where the update interval is auto adjusted by
the controller based on load information.
Area Enter a 64 character maximum description for the selected device’s physical deployment area. This
area can be further refined by floor and floor number descriptions.
Floor Enter a 32 character maximum description for the selected device’s building floor placement. This area
can be further refined by floor and floor number descriptions.
Floor Number Use the spinner control to assign a numeric deployment floor number (from 1 - 4094) for this device.
The default floor is 1.