Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 703)

Brocade Mobility RFS Controller System Reference Guide 691
53-1003099-01
13
3. Select the Add to Active Filters button to create a new filter and add it to the Active Event Filters
table. When added, the filter uses the current configuration defined in the Customize Event
Filters field.
4. Refer to the Active Event Filters table to set the following parameters for the Fault Management
configuration:
a. To activate all the events in the Active Events Filters table, select the Enable All Events
button. To stop event generation, select Disable All Events.
b. To enable an event in the Active Event Filters table, click the event to select it. Then, select
the Activate Defined Filter button.
NOTE
Filters cannot be persisted across sessions. They have to be created every time a new session is
established.
5. Select View Events from the upper, left-hand, side of the Diagnostics > Fault Management
menu.
FIGURE 2 Fault Management View Events screen
Use the View Events screen to track and troubleshoot events using the source and severity
levels defined in the Configure events screen.