Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 141)

Brocade Mobility RFS Controller System Reference Guide 129
53-1003099-01
5
FIGURE 49 Profile Overrides -PPPoE screen
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
6. Use the Basic Settings field to enable PPPoE and define a PPPoE client
7. Define the following Authentication parameters for PPPoE client interoperation:
Enable PPPoE Select Enable to support a high speed client mode point-to-point connection using the PPPoE
protocol. The default setting is disabled.
Service Enter the 128 character maximum PPPoE client service name provided by the service
provider.
DSL Modem Network
(VLAN) Use the spinner control to set the PPPoE VLAN (client local network) connected to the DSL
modem. This is the local network connected to DSL modem. The available range is 1 - 4,094.
The default VLAN is VLAN1
Client IP Address Provide the numerical (non hostname) IP address of the PPPoE client.
Username Provide the 64 character maximum username used for authentication support by the PPPoE
client.