Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 340)

328 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
6
18. Select OK to update the Smart RF Interference Recovery settings for this policy. Select Reset to
revert to the last saved configuration.
19. Select the Coverage Hole Recovery tab.
FIGURE 44 Smart RF Advanced Configuration screen - Coverage Hole Recovery tab
Channel Hold Time Defines the minimum time between channel changes during neighbor recovery. Set the time in
either Seconds (0 - 86,400), Minutes (0 - 1,440) or Hours (0 - 24) or Days (0 - 1). The default
setting is 30 minutes.
Client Threshold Use the spinner to set a client threshold for the Smart RF policy between 1 - 255. If the set
threshold number of clients are connected to a radio, it does not change its channel even though it
requires one, based on the interference recovery determination made by the smart master. The
default is 50.
5.0 GHz Channel Switch
Delta Use the spinner to set a channel interference delta (between 5 - 35 dBm) for the 5.0 GHz radio.
This parameter is the difference between interference levels on the current channel and a
prospective channel. If the difference is below the configured threshold, the channel will not
change. The default setting is 20 dBm.
2.4 GHz Channel Switch
Delta Use the spinner to set a channel interference delta (between 5 - 35 dBm) for the 2.4 GHz radio.
This parameter is the difference between interference levels on the current channel and a
prospective channel. If the difference is below the configured threshold, the channel will not
change. The default setting is 20 dBm.