Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 538
526
Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
11. Select the Path Method SNR tab to configure signal to noise (SNR) ratio values when selecting
the path to the meshpoint root.
FIGURE 96
Mesh Point Auto Channel Selection - Path Method SNR screen
Off-channel Duration
Set the duration (from 20 - 250 milliseconds) the scan dwells on each channel when performing
an off channel scan. The default is 50 milliseconds.
Off-channel Scan
Frequency
Set the duration (from 1- 60 seconds) between two consecutive off channel scans. The default is 6
seconds.
Meshpoint Root - Sample
Count
Configure the number of scan samples (from 1- 10) performed for data collection before a mesh
channel is selected. The default is 5.
Meshpoint Root - Channel
Hold Time
Configure the duration (from 0 - 1440 minutes) to remain on a channel before channel conditions
are reassessed for a possible channel change. Set this value to zero (0) to prevent an automatic
channel selection from occurring. The default setting is 30 minutes.