Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 180)

168 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 72 Profile Overrides - Network Bridge VLAN screen, General tab
The General tab displays by default.
8. If adding a new Bridge VLAN configuration, use the spinner control to define or override a VLAN
ID between 1 - 4094. This value must be defined and saved before the General tab can
become enabled and the remainder of the settings defined. VLAN IDs 0 and 4095 are
reserved and unavailable.
9. Set or override the following General bridge VLAN parameters:
Description If creating a new Bridge VLAN, provide a description (up to 64 characters) unique
to the VLAN’s specific configuration to help differentiate it from other VLANs with
similar configurations.
Per VLAN Firewall Enable this setting to provide firewall allow and deny conditions over the bridge
VLAN. This setting is enabled by default.
L2 Tunnel Broadcast
Optimization Select this option to enhance (optimize) layer 2 traffic broadcast packet
transmissions. This settings is disabled by default.