Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 58)

46 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
4. The Basic Configuration screen displays by default.
FIGURE 2 Basic Configuration screen
5. Set the following Configuration settings for the target device:
System Name Provide the selected device a system name up to 64 characters. This is the device name that appears
within the RF Domain or Profile the device supports.
Area Assign the device an Area name representative of the location the controller or service platform was
physically deployed. The name cannot exceed 64 characters. Assigning an area name is helpful when
grouping devices in RF Domains and profiles, as devices in the same physical deployment location may
need to share specific configuration parameters in respect to radio transmission and interference
requirements specific to that location.