Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 156)

144 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
The screen displays existing GRE configurations.
5. Select the Add button to create a new GRE tunnel configuration or select an existing tunnel and
select Edit to modify its current configuration. To remove an existing GRE tunnel, select it from
amongst those displayed and select the Delete button
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override, go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
FIGURE 58 Profile Overrides - Network GRE screen
6. If creating a new GRE configuration, assign it a 32 character maximum name to distinguish its
configuration.
7. Define the following settings for the GRE configuration:
DSCP Options Use the spinner control to set the tunnel DSCP / 802.1q priority value from
encapsulated packets to the outer packet IPv4 header.
Tunneled VLANs Define the VLAN connected clients use to route GRE tunneled traffic within their
respective WLANs.