Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 234)

222 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
11. Select OK to save the changes and overrides made to the profile’s Management Settings.
Select Reset to revert to the last saved configuration.
12. Select Firmware from the Management menu.
FIGURE 110 Profile Overrides - Management Firmware screen
13. Refer to the Auto Install via DHCP Option field to configure automatic configuration file and
firmware updates.
Enable Configuration
Update Select Enable Configuration Update (from within the Automatic Configuration Update field) to
enable automatic profile configuration file updates from an external location.
If enabled (the setting is disabled by default), provide a complete path to the target configuration file
used in the update.
Enable Firmware Update Select this option to enable automatic firmware upgrades (for this profile) from a user defined
remote location. This value is disabled by default.
Start Time (minutes) Use the spinner control to set the number of minutes to delay the start of an auto upgrade
operation. Stagger the start of an upgrade operation as needed in respect to allowing an Access
Point to complete its current client support activity before being rendered offline during the update
operation. The default setting is 10 minutes.