Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 672)

660 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
11
FIGURE 30 HTTP Access Rule - Add/Edit screen
2. Set the following HTTP Access Rules:
3. Select OK to save the HTTP access rule configuration. Select Reset to revert to the last saved
configuration.
Precedence Set a precedence value to determine the order HTTP access rules are applied. The available range is 1
- 100. The lower the integer, the high the priority.
Permit When enabled, HTTP requests that match this rule are permitted. If not enabled, HTTP requests that
match this rule are denied. The default setting is disabled.
Source IP Set the IP matched against the source (origination) IP address of the HTTP request.
Destination IP Set the IP matched against the origin server's IP address obtained from the HTTP request URL.
Destination Domain Set the destination domain to match against the hostname in the HTTP request URL.
Destination Domain
Regex The destination domain regex is the same as the destination domain, but the destination domain regex
allows an administrator to use regular expressions matching on origin server names.
URL Regex Set the expressions used to match any part of a requested URL, including the transfer protocol and the
origin server hostname.
Mimtype Regex Select this response parameter to use any regular expression to match a part of a smart caching
request. When enabled, regular expressions are used to match the mimetype of a HTTP request.