Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 739)

Brocade Mobility RFS Controller System Reference Guide 727
53-1003099-01
14
FIGURE 23 Certificate Management - Import New RSA Key screen
7. Define the following parameters required for the Import of the RSA key:
8. Select OK to import the defined RSA key. Select Cancel to revert the screen to its last saved
configuration.
Key Name Enter the 32 character maximum name assigned to identify the RSA key.
Key Passphrase Define the key used by both the controller or service platform and the server (or repository) of the target
RSA key. Select the Show
to expose the actual characters used in the passphrase. Leaving the Show
unselected displays the passphrase as a series of asterisks “*”.
URL Provide the complete URL to the location of the RSA key. If needed, select Advanced to expand the
dialog to display network address information to the location of the target key. The number of additional
fields that populate the screen is dependent on the selected protocol.
Advanced / Basic Select either the Advanced or Basic link to switch between a basic URL and an advanced location to
specify key location.
Protocol Select the protocol used for importing the target key. Available options include:
tftp
ftp
sftp
http
cf
usb1-4
Port Use the spinner control to set the port. This option is not valid for cf and usb1-4.
Host Provide the hostname or numeric IP address of the server used to import the RSA key. This option is not
valid for cf and usb1-4.
Path/File Specify the path to the RSA key. Enter the complete relative path to the key on the server.