Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 98)

86 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 26 Access Point Adoption Override screen
5. Define or override the Preferred Group used as optimal group for the Access Point’s adoption.
The name of the preferred group cannot exceed 64 characters.
6. Set the following Controller Hello Interval settings manage message exchanges and
connection re-establishments between adopting devices:
7. Select the check box to define or override a VLAN the Access Point’s associating controller or
service platform is reachable on.
VLANs 0 and 4,094 are reserved and cannot be used by a controller or service platform
VLAN.
8. Enter Controller Hostnames as needed to define or override resources for Access Point
adoption.
Hello Interval Define an interval (from 1 - 120 seconds) between hello keep alive messages
exchanged with the adopting device. These messages serve as a connection
validation mechanism to ensure the availability of the adopting resource.
Adjacency Hold Time Set the time (from 2 - 600 seconds) after the last hello packet after which the
connection between the controller and Access Point is defined as lost and their
connection is re-established. When a hello interval is set, an adjacency hold time is
mandatory and should be higher then the hello interval.