Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 589)

Brocade Mobility RFS Controller System Reference Guide 577
53-1003099-01
10
FIGURE 6 MAC Firewall Rules Add/Edit screen
4. If adding a new MAC Firewall Rule, provide a name up to 32 characters.
5. Define the following parameters for the MAC Firewall Rule:
Allow Every MAC firewall rule is made up of matching criteria rules. The action defines what to do with the
packet if it matches the specified criteria. The following actions are supported:
Deny - Instructs the firewall to prevent a packet from proceeding to its destination.
Permit - Instructs the firewall to allow a packet to proceed to its destination.
VLAN ID Enter a VLAN ID representative of the shared SSID each user employs to interoperate within the network
(once authenticated by the local RADIUS server). The VLAN ID can be between 1 and 4094.
Match 802.1P Configures IP DSCP to 802.1p priority mapping for untagged frames. Use the spinner control to define a
setting between 0 - 7.
Source and
Destination MAC Enter both Source and Destination MAC addresses. The source IP address and destination MAC address
are used as basic matching criteria. Provide a subnet mask if using a mask.