Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 466
454
Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
FIGURE 44
OSPF Area Configuration screen
13. Set the OSPF Area configuration.
14. Select the OK button to save the changes to the area configuration. Select Reset to revert to
the last saved configuration.
15. Select the Interface Settings tab.
Area ID
Use the drop down menu and specify either an IP address or Integer for the OSPF area.
Authentication Type
Select either None, simple-password or message-digest as the credential validation
scheme used with the OSPF dynamic route. The default setting is None.
Type
Set the OSPF area type as either stub, totally-stub, nssa, totally-nssa or non-stub.
Default Cost
Select this option to set the default summary cost advertised if creating a stub. Set a value
from 1 - 16, 777,215.
Translate Type
Define how messages are translated. Options include translate-candidate, translate always
and translate-never. The default setting is translate-candidate.
Range
Specify a range of addresses for routes matching the address/mask for OSPF
summarization.