Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 913)

Brocade Mobility RFS Controller System Reference Guide 901
53-1003099-01
15
FIGURE 110 Access Point - Policy Based Routing screen
The Policy Based Routing screen displays the following:
Precedence Lists the numeric precedence (priority) assigned to each listed PBR configuration. A route-map consists of
multiple entries, each carrying a precedence value. An incoming packet is matched against the route-map
with the highest precedence (lowest numerical value).
Primary Next Hop
IP Lists the IP address of the virtual resource that, if available, is used with no additional route considerations.
Primary Next Hop
State Displays whether the primary hop is applied to incoming routed packets (UP/UNREACHABLE).
Secondary Next
Hop IP If the primary hop is unavailable, a second resource is used. This column lists the address set for the
alternate route in the election process.
Secondary Next
Hop State Displays whether the secondary hop is applied to incoming routed packets (UP/UNREACHABLE).
Default Next Hop
IP If a packet subjected to PBR does not have an explicit route to the destination, the configured default next
hop is used. This is either the IP address of the next hop or the outgoing interface. Only one default next hop
is available. The difference between the next hop and the default next-hop is in case of former, PBR occurs
first, then destination based routing. In case of the latter, the order is reverse.
Default Next Hop
State Displays whether the default hop is being applied to incoming routed packets.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.