Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 689)

Brocade Mobility RFS Controller System Reference Guide 677
53-1003099-01
12
FIGURE 5 Management Policy screen - Access Control tab
2. Set the following parameters required for Telnet access:
3. Set the following parameters required for SSH access:
Enable Telnet Select the checkbox to enable Telnet device access. Telnet provides a command line interface to a
remote host over TCP. Telnet provides no encryption, but it does provide a measure of
authentication. Telnet access is disabled by default.
Telnet Port Set the port on which Telnet connections are made (1 - 65,535). The default port is 23. Change
this value using the spinner control next to this field or by entering the port number in the field.
Enable SSHv2 Select the checkbox to enable SSH device access. SSH (Secure Shell) version 2, like Telnet,
provides a command line interface to a remote host. SSH transmissions are encrypted and
authenticated, increasing the security of transmission. SSH access is disabled by default.
SSHv2 Port Set the port on which SSH connections are made. The default port is 22. Change this value using
the spinner control next to this field or by entering the port number in the field.