Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 33)

Brocade Mobility RFS Controller System Reference Guide 21
53-1003099-01
3
• Time Zone - Set the time zone where the controller or service platform is deployed. This is
a required parameter. The setting should be complimentary with the selected deployment
country.
Refer to the Select protocols that will be enabled for device access area and enable those
controller or service platform interfaces for accessing the controller or service platform. HTTP and
Telnet are considered relatively insecure and only should be enabled is necessary.
Select Next. The wizard displays the Summary and Commit screen to summarize the screens
(pages) and settings updated using the wizard.
FIGURE 9 Initial Setup Wizard - Summary and Commit
No user intervention or additional settings are required within this screen. Its an additional
means of validating the Access Point’s updated configuration before its deployed.
However, if a screen displays settings not intended as part of the initial configuration, the
any screen can be selected again from within the Navigation Panel and its settings
modified accordingly.
If the configuration displays as intended, select Save/Commit to implement these settings to the
controller or service platform configuration. If additional changes are warranted based on the
summary, either select the target page from the Navigational Panel, or use the Back and Next
buttons to scroll to the target screen.