Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 939
Brocade Mobility RFS Controller System Reference Guide
927
53-1003099-01
15
FIGURE 128
Access Point - VRRP screen
4. Refer to the Global Error Status field to review the various sources of packet errors logged
during the implementation of the virtual route.
Errors include the mismatch of authentication credentials, invalid packet checksums,
invalid packet types, invalid virtual route IDs, TTL errors, packet length errors and invalid
(non matching) VRRP versions.
5. Refer to the Router Operations Summary for the following status:
VRID
Lists a numerical index (1 - 254) used to differentiate VRRP configurations. The index is assigned when
a VRRP configuration is initially defined. This ID identifies the virtual router a packet is reporting status
for.
Virtual IP Address
Lists the virtual interface IP address used as the redundant gateway address for the virtual route.
Master IP Address
Displays the IP address of the elected VRRP master. A VRRP master (once elected) responds to ARP
requests, forwards packets with a destination link layer MAC address equal to the virtual router MAC
address, rejects packets addressed to the IP address associated with the virtual router and accepts
packets addressed to the IP address associated with the virtual router.
Interface Name
Displays the interfaces selected on the Access Point to supply VRRP redundancy failover support.
Version
Display VRRP version 3 (RFC 5798) or 2 (RFC 3768) as selected to set the router redundancy. Version 3
supports sub-second (centisecond) VRRP failover and support services over virtual IP.
State
Displays the current state of each listed virtual router ID.
Clear Router Status
Select the Clear Router Status button to clear the Router Operations Summary table values to zero and
begin new data collections.
Clear Global Error
Status
Select the Clear Global Error Status
button to clear the Global Error Status table values to zero and
begin new data collections.
Refresh
Select the Refresh button to update the screen’s statistics counters to their latest values.