Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 537)

Brocade Mobility RFS Controller System Reference Guide 525
53-1003099-01
8
FIGURE 95 Mesh Point Auto Channel Selection - Dynamic Root Selection screen
The Dynamic Root Selection screen displays by default. The Dynamic Root Selection
screen provides configuration options for the 2.4 GHz and 5.0/4.9 GHz frequencies.
10. Set the following values (common to both 2.4 GHZ and 5.0/4.9 GHz):
Channel Width Set the channel width the meshpoint’s automatic channel scan assigns to the selected radio.
Available options include:
•
Automatic – Defines the channel width is calculated automatically. This is the default value.
•
20 MHz – Sets the width between two adjacent channels as 20 MHz.
•
40 MHz – Sets the width between two adjacent channels as 40 MHz.
Priority Meshpoint Configure the meshpoint monitored for automatic channel scans. This is the meshpoint assigned
priority over other available mesh points. When configured, a mesh connection is established with
this mesh point. If not configured, a meshpoint is automatically selected. This setting is disabled by
default.