Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 704)

692 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
13
6. Define the following Customize Event Filters parameters for the Fault Management
configuration:
7. Select Clear All to clear events and begin new event data gathering.
8. Select Event History from the upper, left-hand, side of the Diagnostics > Fault Management
menu.
FIGURE 3 Fault Management Event History screen
The Event History screen displays events for controllers, service platforms and Access
Points. The Controller(s) tab displays by default. Information on this tab can be filtered by
controllers and service platforms, then further by a RF Domain. Similarly, the Access
Point(s) tab displays information for each RF Domain on the Access Point and this
information can be further filtered on the devices adopted by this access point.
Timestamp Displays the Timestamp (time zone specific) when the fault occurred.
Module Displays the module used to track the event. Events detected by other module are not tracked.
Message Displays error or status messages for each event listed.
Severity Displays the severity of the event as defined for tracking from the Configuration screen. Severity options
include:
All Severities – All events are displayed irrespective of their severity
Critical – Only critical events are displayed
Error – Only errors and above are displayed
Warning – Only warnings and above are displayed
Informational – Only informational and above events are displayed
Source Displays the MAC address of the tracked source device.
Hostname Lists the administrator assigned hostname of the tracked source device.