Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 620)

608 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
10
6. Define the following Settings for the Advanced WIPS policy:
7. Refer to the Wireless Client Termination table to set list of up to 100 client MAC addresses that
will be blocked with this Advanced WIPS policy. This clients are removed from connection
within the managed network, so be sure they represent potential threats.
8. Select OK to save the updates to the Advanced WIPS Settings tab. Select Reset to revert to the
last saved configuration.
9. Select the Events List tab to display a screen where individual events can be enabled as
sanctioned or unsanctioned for the managed network.
FIGURE 28 Advanced WIPS Policy screen - Events List tab
Events are tracked based on an AP’s authorization. APs are either Sanctioned, Unsanctioned
or Neighboring. All of the events listed do not necessarily support all the three AP types.
Some events have extra configurable parameters. These events are identified by a small
triangle under the More column. Extra event parameters are displayed at the right of the
screen.
Wireless Controller
Port Use the spinner control to set the port the advanced WIPS daemon listens over. The default port is 8,443.
Device Categorization Set the device categorization as sanctioned, unsanctioned etc. Select the Create icon to create a new
Device Category configuration, or the Edit
icon to modify the configuration of an existing configuration.