Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 439
Brocade Mobility RFS Controller System Reference Guide
427
53-1003099-01
8
When the Access Point initiates a PPPoE session, it first performs a discovery to identify the
Ethernet MAC address of the PPPoE client and establish a PPPoE session ID. In discovery, the
PPPoE client discovers a server to host the PPPoE connection.
To create a PPPoE point-to-point configuration
1. Select Configuration > Profiles > Interface.
2. Expand the Interface menu to display its submenu options.
3. Select PPPoE.
FIGURE 27
Profile -PPPoE screen
4. Use the Basic Settings field to enable PPPoE and define a PPPoE client
Enable PPPoE
Select Enable to support a high speed client mode point-to-point connection using the
PPPoE protocol. The default setting is disabled.
Service
Enter the 128 character maximum PPPoE client service name provided by the service
provider.
DSL Modem Network
(VLAN)
Use the spinner control to set the PPPoE VLAN (client local network) connected to the DSL
modem. This is the local network connected to DSL modem. The available range is 1 -
4,094. The default VLAN is VLAN1.
Client IP Address
Provide the numerical (non hostname) IP address of the PPPoE client.