Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 343)

Brocade Mobility RFS Controller System Reference Guide 331
53-1003099-01
6
3. Select Add to create a new MeshConnex policy, Edit to modify the attributes of a existing policy
or Delete to remove obsolete policies from the list of those available.
The Configuration screen displays by default for the new or modified MeshConnex policy.
FIGURE 46 MeshConnex Configuration screen
4. Refer to the Configuration section to define a MeshConnex profile.
Control VLAN Displays the VLAN (virtual interface ID) for the control VLAN on each of the configured mesh points.
Allowed VLANs Displays the list of VLANs allowed on each configured mesh point.
Security Mode Displays the security assigned to each configured mesh point. The field displays None for no
security or PSK for pre-shared key authentication.
Mesh QoS Policy Displays the mesh Quality of Service policy associated to each configured mesh point.
Mesh Point Name Specify a name for the new mesh point. The name should be descriptive to easily differentiate it
from other mesh points. This field is mandatory.
Mesh Id Specify a mesh identifier for this mesh point. This field is optional.
Mesh Point Status To enable this mesh point, click the Enabled radio button. To disable the mesh point click the
Disabled button.The default value is enabled.
Mesh QoS Policy Use the drop-down menu to specify the mesh Quality of Service policy to use on this mesh point.
This value is mandatory. If no suitable Mesh QoS policies exist, click the create icon to create a new
Mesh QoS policy.
Beacon Format Use the drop-down menu to specify the format for beacon transmissions. To use Access Point style
beacons, select access-point from the drop-down menu. To use mesh point style beacons, select
mesh-point. The default value is mesh-point.
is Root Select this option to specify the mesh point as a root.