Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 449)

Brocade Mobility RFS Controller System Reference Guide 437
53-1003099-01
8
13. Select OK to save the peer configuration.
14. Refer to the Session table to review the configurations of the peers available for tunnel
connection.
15. Select + Add Row to populate the table with configurable session parameters for this tunnel
configuration.
FIGURE 34 Network - L2TPv3 screen, Add T2TP Peer Configuration
16. Define the following Session parameters:
Encapsulation Select either IP or UDP as the peer encapsulation protocol. The default setting is IP. UDP
uses a simple transmission model without implicit handshakes.
UDP Port If UDP encapsulation is selected, use the spinner control to define the UDP encapsulation
port.
IPSec Secure Enable this option to enable security on the connection between the Access Point and the
Virtual Controller.
IPSec Gateway Specify the IP Address of the IPSec’s secure gateway resource used to protect tunnel traffic.
Name Enter a 31 character maximum session name. There is no idle timeout for a tunnel. A tunnel
is not usable without a session and a subsequent session name. The tunnel is closed when
the last session tunnel session is closed.
Pseudowire ID Define a psuedowire ID for this session. A pseudowire is an emulation of a layer 2
point-to-point connection over a packet-switching network (PSN). A pseudowire was
developed out of the necessity to encapsulate and tunnel layer 2 protocols across a layer 3
network.
Traffic Source Type Lists the type of traffic tunnelled in this session.
Traffic Source Value Define a VLAN range (virtual LAN resources) to include in the tunnel session. Available VLAN
ranges are from 1 - 4,094.